a)
Lubricating hole sealed with plastic cap
M8x1 (Ø d 20 – 50 mm)
M10x1 (Ø d = 60 mm)
| D | 90 | mm | |
| E1 | 132 mm ±0.2 | ||
| E3 | 132 | mm | |
| H | 60 | mm | |
| H1 | 125 | mm | |
| Linie | 126 | mm | |
| N1 | 59 | mm | |
| S | 17,50 | ||
| S2 | 12 | ||
| Ventil | 13 | mm |
| Industriekomponente | 164 | mm | |
| E2 | 65 mm ±0.2 | ||
| E4 | 108 | mm | |
| Toleranz für H (Clamped (fastened) in relation to Ø d.) | + 8 - 16 |
||
| H4 | 45 | mm | |
| Maschinenschutz (Clamped (fastened) in relation to Ø d.) | 82 mm ±0.01 | ||
| N2 | 42 | mm | |
| S1 | M20 | ||
| Schalter | 10 |
| amax | 150 | m/s² | |
| Maschinenschutz | 5,20 | kg | |
| Losbrechkraft | 18 | N | |
| Betriebsbedingungen | Operating conditions |
| vmax | 5 | m/s | |
| FR (Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 7 | N | |
| Radialluft | Comes clamped to h5 shaft (lower limit) and set to zero clearance | ||
| Zulässige Umgebungstemperatur (min ... max) | -20 °C ... +80 °C |
