| D | 26 | mm | |
| A1 (Tolerance ISO 8062-3 - DCTG 9.) | 26 | mm | |
| B1 | 22 | mm | |
| E2 | 26 mm ±0.15 | ||
| Toleranz für H (Clamped (fastened) in relation to Ø d.) | + 8 - 16 |
||
| Linie | 36 | mm | |
| Schalter | 3 |
| Industriekomponente (Tolerance ISO 8062-3 - DCTG 9.) | 50 | mm | |
| B (Tolerance ISO 8062-3 - DCTG 9.) | 35 | ||
| E1 | 40 mm ±0.15 | ||
| H | 22 | mm | |
| H1 (Tolerance ISO 8062-3 - DCTG 9.) | 42 | mm | |
| S | 4,50 | ||
| Ventil (Tolerance ISO 8062-3 - DCTG 9.) | 6,50 | mm |
| Zulässige Umgebungstemperatur (min ... max) | -10 °C ... +80 °C | ||
| vmax (Speeds of up to 5 m/s possible. Service life is limited by heightened wear to plastic parts. Tests have shown total travel from 50 • 105 m to 100 • 105 m without failure. ) | 3 | m/s | |
| FR (Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 1 | N | |
| Radialluft | Comes clamped to h5 shaft (lower limit) and set to zero clearance |
| amax | 150 | m/s² | |
| Maschinenschutz | 0,24 | kg | |
| Losbrechkraft | 2 | N | |
| Betriebsbedingungen | Operating conditions |
