a)
Lubricating hole M8 x 1 sealed with plastic cap
b)
Vent hole
c)
Mounting options
d)
Via drill hole S
e)
Via thread S1
f)
Via drill hole S
g)
Centering via collar D2
| D | 22 | mm | |
| D2 (Recommended installation: Mounting hole D2H7. ) | 30 | mm | |
| Toleranz für D3 | - 100 - 300 |
||
| E2 | 24 mm ±0.15 | ||
| H3 | 19 | mm | |
| L1 | 46 | mm | |
| N1 | 13 | mm | |
| S (Fixing screws ISO 4762-8.8) | 5,30 | ||
| Ventil | 10 | mm |
| B | 42 | ||
| D3 | 30 | mm | |
| E1 | 32 mm ±0.15 | ||
| H | 34 | mm | |
| Linie | 76 | mm | |
| L1 | 46 mm | ||
| N2 | 36 | mm | |
| S1 | M6 |
| amax | 150 | m/s² | |
| Maschinenschutz | 0,20 | kg | |
| Losbrechkraft | 1,50 | N | |
| Betriebsbedingungen | Operating conditions |
| vmax (Speeds of up to 5 m/s possible. Service life is limited by heightened wear to plastic parts. Tests have shown total travel from 50 • 105 m to 100 • 105 m without failure. ) | 3 | m/s | |
| FR (Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 0,80 | N | |
| Radialspiel der Welle h6 | + 38 + 10 |
||
| Zulässige Umgebungstemperatur (min ... max) | -10 °C ... +80 °C |
