| D | 16 | mm | |
| C1 | 16,20 | H13 | |
| D1 | 14,70 | mm |
| C | 25 | mm | |
| C2 | 1,10 |
| amax | 100 | m/s² | |
| Maschinenschutz | 0,02 | kg | |
| Losbrechkraft (One wiper seal: Multiply by a factor of 0.5.) | 1 | N | |
| Kugelreihen | 4 | ||
| Radialspiel der Welle h6 (Determined from working bore diameter and shaft tolerance statistics. Recommended housing bore tolerance: H6 or H7. ) | + 18 + 5 |
||
| Zulässige Umgebungstemperatur (min ... max) (Only unsealed Linear Bushings with steel ball retainers may be used at higher temperatures. Make allowance for reductions in load capacity. ) | -10 °C ... +80 °C |
| vmax | 2,50 | m/s | |
| FR (One wiper seal: Multiply by a factor of 0.5.,Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 0,50 | N | |
| Maschinenschutz (Friction coefficients of unsealed Linear Bushings when lubricated with oil. The friction coefficient is lowest under heavy load, but can still be above the specified value even under a low load. ) | 0,001 ... 0,004 | ||
| Toleranz des Arbeitsbohrungsdurchmessers | + 12 + 2 |
||
| Betriebsbedingungen | Operating conditions |