| D | 120 | mm | |
| C1 | 133,30 | H13 | |
| D1 | 114 | mm |
| C | 165 | mm | |
| C2 | 4,15 |
| amax | 50 | m/s² | |
| Maschinenschutz | 4,70 | kg | |
| Losbrechkraft (One wiper seal: Multiply by a factor of 0.5.) | 45 | N | |
| Kugelreihen | 6 | ||
| Radialspiel der Welle h6 (Determined from working bore diameter and shaft tolerance statistics. Recommended housing bore tolerance: H6 or H7. ) | + 37 + 8 |
||
| Zulässige Umgebungstemperatur (min ... max) (Only unsealed Linear Bushings with steel ball retainers may be used at higher temperatures. Make allowance for reductions in load capacity. ) | -10 °C ... +80 °C |
| vmax | 2 | m/s | |
| FR (One wiper seal: Multiply by a factor of 0.5.,Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 15 | N | |
| Maschinenschutz (Friction coefficients of unsealed Linear Bushings when lubricated with oil. The friction coefficient is lowest under heavy load, but can still be above the specified value even under a low load. ) | 0,001 ... 0,004 | ||
| Toleranz des Arbeitsbohrungsdurchmessers | + 24 + 2 |
||
| Betriebsbedingungen | Operating conditions |