| D | 75 | mm | |
| A1 (Tolerance ISO 8062-3 - DCTG 9.) | 57 | mm | |
| B1 (Tolerance ISO 8062-3 - DCTG 9.) | 72 | mm | |
| E2 | 50 mm ±0.2 | ||
| Toleranz für H (Clamped (fastened) in relation to Ø d.) | + 13 - 21 |
||
| Linie | 100 | mm | |
| Schalter | 8 |
| Industriekomponente (Tolerance ISO 8062-3 - DCTG 9.) | 130 | mm | |
| B (Tolerance ISO 8062-3 - DCTG 9.) | 70 | ||
| E1 | 108 mm ±0.2 | ||
| H | 50 | mm | |
| H1 (Tolerance ISO 8062-3 - DCTG 9.) | 105 | mm | |
| S | 9 | ||
| Ventil (Tolerance ISO 8062-3 - DCTG 9.) | 14 | mm |
| amax | 150 | m/s² | |
| Maschinenschutz | 3,23 | kg | |
| Losbrechkraft | 10 | N | |
| Betriebsbedingungen | Operating conditions |
| vmax (Speeds of up to 5 m/s possible. Service life is limited by heightened wear to plastic parts. Tests have shown total travel from 50 • 105 m to 100 • 105 m without failure. ) | 3 | m/s | |
| FR (Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 4 | N | |
| Radialspiel der Welle h6 | + 50 + 12 |
||
| Zulässige Umgebungstemperatur (min ... max) | -10 °C ... +80 °C |
