a)
Lubricating hole M8 x 1 sealed with plastic cap
| D | 40 | mm | |
| E3 | 94 mm ±0.15 | ||
| E5 | 42 | ||
| H | 30 | mm | |
| H1 | 60 | mm | |
| H4 | 20 | mm | |
| Maschinenschutz (Clamped (fastened) in relation to Ø d.) | 39 mm ±0.01 | ||
| N3 | 22 | mm | |
| S3 | M10 | ||
| Schalter | 5 |
| B1 | 78 | mm | |
| E4 | 60 mm ±0.15 | ||
| E6 | 64 | mm | |
| Toleranz für H (Clamped (fastened) in relation to Ø d.) | + 8 - 16 |
||
| H3 | 15 | mm | |
| Linie | 130 | mm | |
| N2 | 29 | mm | |
| S2 (Fixing screws ISO 4762-8.8) | 8,40 | ||
| S4 (Pin hole centering.) | 6 | mm | |
| Ventil | 6,50 | mm |
| amax | 150 | m/s² | |
| Maschinenschutz | 1,35 | kg | |
| Losbrechkraft | 4,50 | N | |
| Betriebsbedingungen | Operating conditions |
| vmax (Speeds of up to 5 m/s possible. Service life is limited by heightened wear to plastic parts. Tests have shown total travel from 50 • 105 m to 100 • 105 m without failure. ) | 3 | m/s | |
| FR (Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 2 | N | |
| Radialluft | Comes clamped to h5 shaft (lower limit) and set to zero clearance | ||
| Zulässige Umgebungstemperatur (min ... max) | -10 °C ... +80 °C |
