| Contact angle | α | 40 | ° |
| Caliber diameter on inner ring wide side face | d2 | 19.70 | mm |
| Caliber diameter on outer ring small side face | D3 | 32.10 | mm |
| Shoulder diameter on outer ring wide side face | D1 | 27.60 | mm |
| Distance between the apexes of the pressure cones | a | 16 | mm |
| Shoulder diameter on inner ring wide side face | d1 | 22.80 | mm |
| Caliber diameter on outer ring wide side face | D2 | 29.20 | mm |
| Minimum chamfer dimension | rmin | 0.30 | mm |
| Maximum fillet radius of housing | ra1 max | 0.30 | mm |
| Maximum diameter of housing shoulder | Db max | 32.60 | mm |
| Minimum diameter of shaft shoulder | da min | 19.20 | mm |
| Maximum fillet radius of shaft | ra max | 0.60 | mm |
| Maximum diameter of housing shoulder | Da max | 30.80 | mm |
| Limiting speed | nG | 12,800 | |
| Basic static load rating, radial | C0r | 4,450 | |
| Width | B | 11 | mm |
| Bore diameter | d | 15 | mm |
| Fatigue load limit, radial | Cur | 305 | N |
| Basic dynamic load rating, radial | Cr | 8,900 | |
| Outside diameter | D | 35 | mm |
